Please do not add more than a 10 Amp fuse to the positive input or it will void the warranty of the converter. Please add a 10 Amp fuse to the positive input wire to protect the converter from overload. Please add a switch to the positive input wire to help with battery drain from the no load current of 20 mA, if the vehicle is not used regularly. The output ground would connect to the ground wire of the 12 volt device. The yellow output wire would connect to the 12 volt input of the device. The output wires Black and Yellow provide a 12 volt 4 amp load. For negative ground 6 volt vehicles connect your black input wire to the ground of the vehicle and connect the red input wire to a positive control that would be active when the wire has positive 6 volts. The red wire would connect to your positive ground and the black input wire would connect to your control signal, that would be active when low. The red and black wire are connected to 5-11 volts input up to 8 Amps 6 Volts. Use your 12v car radio in a 6 volt system. For example a 24VDC (voltage found in industrial / heavy gear vehicles) to 12VDC. Works good for Model T and Model A and other 6 volt cars, trucks, tractors and motorcycles. Its role is to Convert from one value / type of voltage to another. Four Wheeler Inverter (246 products available) 300 W Tropicool DC AC Car Inverter, Model: HI-300, Output Frequency: 60 Hz 12 (v) CAR POWER INVERTER 200W, 110. Compatible with 12 Volt: audio, navigation, monitoring, led, air conditioning, electric fans, CB, ham radio, DVD, lights, motors, pumps and industrial equipment. With this ballast you can have DVD, Bluetooth, WIFI, USB port in your vintage and classic vehicles designed and built before World War II. Please connect the output to a 12 Volt device. Please connect the ground and input 6 volt signal to the input side of the ballast such as a cigarette lighter receptacle. The ballast is water proof and is a isolated design. Easy to connect for (DIY) do it yourself retrofit. Long warranty please set page details for further warranty information. Works on both 6 Volt negative ground and 6 Volt positive ground cars, trucks, tractors and motorcycles. The input is 8 Amps 6 Volt input and the output is 4 amps 12 Volt. The ballast has enough power in a small size. For example, if your device requires 2 Amps, it will output 2 Amps.Converts your 6 Volt vehicle to be able to power 12 Volt accessories. Actual output current depends on the device's requirements. *5A is its maximum output current, not actual output current. Safety Protections: Over Current & Over Voltage Protection.Acceptable Input DC Voltage Range :9V ~ 32V.FAILURE TO DO SO MAY RESULT IN SEVERE DAMAGES. Negative on adapter connects to Negative on power source. It is CRITICAL that the power adapter is connected correctly in polarity to the power source: Positive on adapter connects to Positive on power source. If you cut off the connector, it will be two bare wires: red color is for Positive input and the black color is for Negative/Ground input. Input: Input is 5.5 x 2.5mm female connector. It is very easy and flexible to connect with batteries and other power source. The output is a 5.5 x 2.5mm male barrel connector with 18AWG wires. This DC to DC power adapter's input side has 5.5 x 2.5mm Female barrel connector with two 16AWG bare wires.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |